I have found very little information regarding actual flow test results - before and after head porting. Flow testing in Canada is usually done at 28" instead of 10", but the conversion can easily be made.
I am having 43mm intake valves and 37mm exhaust installed.
I would like to see what flows are typical for a 1.6 cvh head.
Air flows at 2mm ,4mm , 6mm, 8mm, 10mm valve lifts would be wonderful.
I am using a hydraulic roller lifter camshaft setup, dual valve springs, and
havent decided on compression ratio yet - probably 8:1
Turbo is a Garrett T3, .48 turbine housing, 55 trim compressor.

I sure hope cylinder head flow test data is available.

Cheers

Perry