Originally Posted by
RAT8OY
Fuckin hell £500!
I dont doubt most places will try that on but in reality you just need the correct grade and diameter bar and a good engineering firm that can cut the spline to copy the standard ones you can supply for them to copy!
TBH I will have custom shafts made up when I go equal length but at the moment I have cut, sleeved and balanced items, which may be a cheaper solution. If your on a budget.
No doubt though, that Luke is talking best of the best no budget limitations!
The shafts i have made are same spec grade material as F1 cars and allow torsional twist. This allows them to take 1000hp.
But yes its not the cheapest but by no means the dearest i was quoted £600 to cut and weld my current ones and be re baleneced.
