Well today i went about seeing how the ancillaries fit etc and as you can see from these pics below its a tight squeeze

inlet and fuel rail fits ok, except the fuel reg im going to have to move it some how ?



then i fitted the turbo and come across another problem that a new would happen



so i m going to have to fab a bracket to sit the turbo back 2 inches so i can get a intake pipe on it

this is where the most chopping had to be done so i can get all the pulleys etc through, once its all fitted i will rebuild this side to regain its strengh and i might put a bolt on cover so if any work needs doing to the front of the lump its easily accessible