I had bettom end knocking so i removed the crank and sure enough the bearings and crank no good. I had the crank reground and they said at the engerneers it is a 1.8 cvh crank,They supplied the bearings to fit my crank but don't fit the rods. Thats where the problems started. I can't get bearings to fit my crank and rods.

I believe to have a 1.9 bored out 1.6 cvh rst block
1.8 cvh crank
mahle pistons

I cant identify the rods with a name such as ford ect.The rods have studs fixed in with a nut that holds the cap on not like standard with a bolt. They are covered in numbers but some are ground out. They are:
22269z2jgsbmlp (on one side)
88218122 w2168???????? (ground out on other side)

The pisons also have these numbers on them if this helps: r101 b2/61

I need to identify these as i cant get parts. Any help would be great as i have a potental scrap engine. any engine buildes on here got any ideas.

_________________