Thread
:
my xr3i project long over due update of the re-rebuild
View Single Post
13-05-2007, 05:13 PM
#
27
DeanO Xr3 CoV
reppin' passionford hard!
Join Date: Dec 2006
Location: Coventry
Posts: 78
Likes: 0
Received 0 Likes on 0 Posts
Whoah man what have you done there??? Is that the whole cab flipped on its side?!! Crazy, but at the same time more practical than what i do, well for sorting out the underneath. As you can see i do my resto work outside, on ramps onda floor, getting my face covered in black crap! After Uni finishes(roll on 1st of June) i'll be bak on it. Heres my thread so far, did this quite a while ago so need to set-up a proper one like yours, few random images in there.
https://passionford.com/forum/viewto...73ccff2ac4d8ba
My battery tray and fuse panel leak aswell, just a crap design really! I think i'm gonna try a short cut on mine and use fibreglass, just can't be arsed with welding! Think if i do that, then paint it up, should be ok. Also gonna channel the water away along the top of the wing where's theres a small lip. Thinking along the lines of silicone sealant running the length of the wing. The rubber bonnet rests that sit in that lip are why the water falls in those trays, so i gonna chop a chunk out so it can run off.
Reply
Like
DeanO Xr3 CoV
View Public Profile
Find More Posts by DeanO Xr3 CoV
View iTrader Profile