Hi all,

Recently bought a S2. The rev counter is not working properly. It has an aftermarket set of dials fitted called plasmadials which look white during the day, but when dark you can go from blue to green and adjust the backlight. They look very bling, but unfortunatley my rev counter is not working!

When the car is ticking over the counter shows approx 1k rpm so is fairly accurate. However it never goes above 2500. It doesn't go erratic, just doesn't go over 2500.

Any ideas? The speedo works fine (and is actually surprisingly accurate to 95 measured against my sat nav). The fuel gauge is a bit slow to come up but does work, as does the temp gauge.

Is it likely the needle has been put back wrong after they were fitted? I have done some research on here and passionford, and read that the feed is a green wire from the dizzy. I think that it is not an intermittant connection as it is constantly reading low, rather than sometimes working and sometimes not. Any help greatly appreciated. DIY cheap fix would be best as I'm skint for 2 weeks!