reet, just building up my ZETEC turbo motor...

just nailed the crank in the block

and was then gonna put the pistons on the rods

and then got a little stuck lol

the pistons (wiseco) have a little dint in the them as they have an offset pin, this points to the timing belt end - i know that much lol

but the rods (carrillo), well, they dont have the usual 1,2,3,4 stamped on them which hains says must face the exhaust side...

they all have 2 stamped on one side, and i guess the part no. on the other.

sooooooooo, should the rods go on the crank with the little cutouts for the tab bits on the big end bearing to locate in, on the exhaust side, or inlet side????

doh

as they were one offs, i gave the pistons and rods to wiseco and never got them back so cant check

help please