Originally Posted by madevelopments
Phils engine uses the same make pistons as Rods and materal but the machining from the blank is diff,
Phils engine will also make 550+hp with the right inlet and may get close to 600hp at 2.5bar, The only thing I would like to change is the Rods for safety.
Mark
Thanks for clearing that up!......I am not too concerned at the Rods as Julian Godfrey says 600bhp is ok..after this they need shot peening..in his experience at power levels over 700bhp he has never seen one let go..BUT in his own engines they are changed to higher spec..which is understandable if you have to warranty it!..Make everything as strong as poss....
So hopefully they will hold out on a road car....
