Started to remove the sump today on 2wd sapph, I have disconnected as per workshop manual,

REMOVED
1, Steering Shaft
2, Power Steering oil cooling loop
3, Power Steering feed line from rack
4, Brack Pipes from crossmember
5, Engine Mount nuts
6, Cross member bolts

cross member still would not drop enough

ALSO NEEDED TO REMOVE (not in workshop manual)

1, power steering from bracket.
2, clutch cable because it run between the sump & cross member.
3, turbo oil return pipe.

BUT the cross member still wont drop enough need to gain about another 30mm

NOT done one before so if anyone can help on this matter I would appreciate it, as I can't think of any thing else appart from releasing the anti roll bar and leaving it hanging from the front struts.