Anyone on here actually using or have used the current Emerald m3d ECU and software? How do you get on with it?
I'm helping out a friend with a saloon race car using an ex-MGF cup K-series engine on throttle bodies. Presently using a Rover MEMS ecu which is pretty impossible to do much with - whilst it runs ok at full throttle which is kinda ok for a race application, it doesn't drive nicely at all, probably due to retaining the MAP sensor, with the feed T'd together from all 4 inlet ports.
The later Emerald m3d is plug'n'play compatible with K-series engine harness and sensors, so makes a lot of sense to go that route.

Any experience input welcome!