Right basically posted bout this a while back but its still not running right.

Its a 1.6 8v and the ONLY way i can get it to start and run is buy unplugging the pipe going to the map sensor and after cranking it a few times it will turn over and run within reason (revs a but high and obivously with the pipe disconnected its causing an air leak!!)

If i leave the pipe on it'll sometimes try 2 turn over but wontand stall..

Basically ive tried another ECU, 2 map sensors, replaced pretty much every sensor bar the crank 1, and replaced all the inlet gaskets as i thought there might be an air leak.

Admiteddly their all 2nd hand sensors/ecu etc ones but should still work.

Out of ideas so any more suggestions before i have 2 take it somewhere?!!?!

Cheers

Tony