Originally Posted by madevelopments
Originally Posted by leecavturbo
Originally Posted by madevelopments
So how was the 1 bar boost map done,
What you will need to do is fix then chack for any other faults then return to the mapper, Then biuld boost up slowly and check the mapping to be safe,
Then do the same as when it went wrong again with mapper carefully check for safety.
Mark
i don't know mapping ,he had the car for approx 1 hour then returned with him saying its now been mapped at 1 bar !, are you saying that not all load points may have been covered ?
For me on Autronic with a car thats already been mapped is plenty of time to cover all the mapping points needed,
Its a pity you didnt drive the car while being mapped then you could tell me what had been done and I could have helped,
Based on the map being said to be very good with what you have said then all you can do is fix then go back and check to see if there is a problem,
There may be another fault some where so be carefull.
Mark
what are your comments on the spikey piston ? but the others where not ?
and that was the failed cylinder ?