403 injector fitting with MD chip
#1
I'm Finding My Feet Here Now
Thread Starter
Join Date: Jul 2006
Location: beds
Posts: 127
Likes: 0
Received 0 Likes
on
0 Posts
403 injector fitting with MD chip
Hi i have just got a 380bhp chip from MD in the fitting instructions it says - Ensure the end caps on the bosh 403 injectors are modified to have a hole of at least 7mm in diameter or cut ends off completely.Dose this refer to the yellow cap on end of the injector? and is it best to just remove them?may be a silly question but dont want to damage them thanks any help welcome
#2
PassionFord Post Whore!!
iTrader: (1)
Join Date: Jun 2003
Location: Essex
Posts: 5,076
Likes: 0
Received 0 Likes
on
0 Posts
I have removed the caps completely on mine when fitting and HAVEN'T had any running probs! just be carefull when fitting injectors into manifold that you dont knock the needle whilst trying to put them into the hole!
#5
PassionFord Post Whore!!
again I bought the 403 fitting kit and left the caps off the end also. I had no problems in doing so, well not unless they have caused the rot underneath the car
Thread
Thread Starter
Forum
Replies
Last Post
big_Rad
General Car Related Discussion.
8
15-09-2017 09:36 AM