Engine management
#1
15000
Thread Starter
Join Date: Jul 2012
Location: ballymena northern ireland
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Engine management
What's the engine management to convert to from MFI and roughly how much would it cost and where is the best place to get it from?
#2
PassionFord Regular
If your after aftermarket management the best advice for you is to find a good well known tuner that work on and know fords that is within reasonable distance from you and speak to them. Every tuner is different and have there own management they like to use, speak to them and tell you what ypur plans are. Prices very massively according to what you want your management to do and what your future plans are with the car. My kms management from devil developments started off at £1250 (a few years ago now) supplied and fitted and on top of that i had to have bigger injectors, fuel pump, map sensor and full lambda control think that took it to around £1800 and that was for an entry level kms ecu. Im kicking myself now that I didnt go for a higher spec ecu as when I had it fitted it was to a basic 200bhp rs turbo now ditched that and gone for a 400bhp zt so make sure you have a goal and stick to it otherwise youll be spending ££££ lol
Last edited by cossirob; 26-02-2015 at 11:18 AM. Reason: .
#3
15000
Thread Starter
Join Date: Jul 2012
Location: ballymena northern ireland
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Thank you for the advice pal. Much appreciated. Not sure if there are many or any at all that have much experience with these cars here in northern ireland
#4
Balls Deep!
iTrader: (4)
As cossirob has said, although just to point out any management can run any power levels assuming your not limited to a small MAP sensor, it has nothing to do with the price.
There must be some tuners in NI? They don't need to have RST experience as they will be fitting everything new, it's only a four cylinder 8v engine so not even slightly complicated to map.
There must be some tuners in NI? They don't need to have RST experience as they will be fitting everything new, it's only a four cylinder 8v engine so not even slightly complicated to map.
Last edited by Karlos G; 28-02-2015 at 02:18 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Stu @ M Developments
General Car Related Discussion.
41
21-08-2015 06:47 AM