Occassionally when pulling out from a junction, my engine dies.

If your quick you can dip the clutch, and rev it again, but usually it'll die again. Then all of a sudden it'll go backto normal.....

Ive had lots of sensors changed and it has been setup and running perfectly.

The only sensor i haven't changed is the ignition Amp.

Before i go and buy one, just wondered if anybody had any idea's of what to check.

Engine is a stage 3 Sapph 4x4 Red Top, 803's, T34 running 24psi held.

 

Ignition amp is actually quite likely.
As a clue, if it is this, the rev counter will just drop like a stone as though you turned teh ignition off when the fault occurs.

 

Thanks Stu,

I'll keep an eye on it the next time it does it...

Cheers , Hopefully that'll be all it is....