i have just done a major overhaul on my car but now have noticed that one little wire which connects to the cylinder head is broken (cut). its a thin wire with the same connector as the oil pressure switch, i think its for the water temperature. anyway the actual connector has broken off and i dont have it does anyone know what i should do as i went to ford and they said they dont sell it.

any advice would be much apprerciated

 

by the way its a series 2 rs turbo

 

Best way mate is just to go to a breakers and cut a new plug off and solder and heat shrink it onto the loom

Of you may find a crimp on connector that fits?

 

thanks again for your help mate, so will any connector that can crimp on to it DO???? i dont really fancy going out searching at the breakers

 

If it fits over it will work, simple as, you will probably find a Blue female bullet connector will be about right

 

you the man

 

No you d'man, and thats the problem (Jay and Silent Bob Strike Back)

 

isn't the lug it sits on threaded anyway? in which case a nut on it would do.

 

that is correct so i am going to use a washer type connector that you would find on some earth straps and use a nut on it. shouldnt be a problem its just i though you may be able to buy the actual connector from somewhere, but obviously not