Stack Dash Rev Gauge
Thread Starter
PassionFord Post Whore!!
iTrader: (1)
Joined: Jul 2003
Posts: 4,542
Likes: 1
From: Bournemouth, Poole, Dorset
Stack Dash Rev Gauge
Wired in Stack all good except REVS.
does not read anything, i am on a P8 wasted spark, not a Stu conversion, enabled in the software Chip.
Anybody else had this issue with stack rev gauge and wasted
Any ideas
Oh the sec is registering revs to let you know abiet 1/2 reading as its wasted
does not read anything, i am on a P8 wasted spark, not a Stu conversion, enabled in the software Chip.
Anybody else had this issue with stack rev gauge and wasted
Any ideas
Oh the sec is registering revs to let you know abiet 1/2 reading as its wasted
15K+ Super Poster!!
Joined: May 2003
Posts: 15,885
Likes: 17
From: Stockport, Cheshire
seems like its not getting anything from the ECU tach output?
As said, connect it to one of the coil pack-ve's - thats where mine is. You then have to set it to 2 cylinder which is 4 cylinder wasted spark.
As said, connect it to one of the coil pack-ve's - thats where mine is. You then have to set it to 2 cylinder which is 4 cylinder wasted spark.
Thread Starter
PassionFord Post Whore!!
iTrader: (1)
Joined: Jul 2003
Posts: 4,542
Likes: 1
From: Bournemouth, Poole, Dorset
Rick i set it 2, will have to try going direct to ignition amp, when i connected the wire the engine revs increase 
Does anyone know what pin out it is, if not i will call Ryan, think it may be a stack fault as its a brand new loom
Does anyone know what pin out it is, if not i will call Ryan, think it may be a stack fault as its a brand new loom
Thread
Thread Starter
Forum
Replies
Last Post
Mark RS
Ford RS Cosworth Parts for Sale
7
Oct 12, 2015 06:01 AM
