As title, this series one inlet has been modified allowing you to use this with cossie / efi management and without the cost of fitting an efi to mfi adaptor plate! . it comes with a fuel rail also. the cossie sensors will fit straight onto this as it's been machined also for these. the top half has also been welded up and re tapped for cossie throttle body fitment.

Pics will follow tomorow if needed??

£80

 

 

That looks very nice Gary

 

looks smart gary any joy with mine

 

Think it's nearly done Will, the machinist has been off sick

 

 

Mercury magic was asking me about one of these earlier ,send him a pm

 

You have PM

 

Just a quick question how do you get a good spray pattern with the inj being in the wrong position ? well its not wrong but not how it should be?
Is it machined out so it drops further in ?

 

Tim
i got one on mine and i ve never had any probs! from what i can see when i stripped mine down it doesnt look to have any machinin to the port where the injector sits!
as for the spray pattern its still aimed at the back of the inlet valve so i dont see any probs with it!

 

hello mate, how much posted to the i.o.w?

 

you getting ideas again Jim?

 

It's machined out so it sits right

Postie, postage would be around £10 i suppose

 

very tidy

 

Sold