Hi,
I am a university student, i am currently investigating 3D printing a distributor for my dissertation. I have got a distributor with the helical gear at the bottom, but not the gear on the jack shaft (auxiliary).
Would it be possible for someone to take a front facing photo of the gear and the rough diameter.

Regards
Bob

 

Dose this help you

 

That is amazing, would it be possible to get a front photo of gear so i can count the teeth.

Regard
Bob

 

18 teeth

 

Hi, sorry just one last question.
I have put it into solidworks but my value for the tooth width is wrong for this gear is wrong, would it be possible to measure these values.
pasteboard.co/IPlAyWw.png
pasteboard.co/IPlBaRe.png

Regards
Bob

 

Wot do you won't ??

 

https://imgur.com/a/eU7gzRa , would it be possible to get measurements for each of these 3 colours.

Regards
Bob

 

Happy to help but your likes are not working for me . When righting your response click on this landscape logo
​​​​​​and upload the photos that way

 

Sorry, this is what i meant by the colours

 

How's this mate any good for you

 

Just one more measurement, how deep is each of the groves , The top of the tooth the the base of the tooth.

Thanks
Bob

 

Ok mate I can sort that but it won't be till tomorrow morning now . But I would of fort it was the same as the one on the dizzy shaft

 

Wow Amazing help and pics there mate

 

Hope this helps out mate