All

Does anyone have the acceptable bearing tolerances for a zetec for the connecting rods and mains please. I am trying to get the service manual which will give me the sizes as new and then as an acceptable service level to check against some plastigauge.

If anyone has the Haynes for a 2.0l zetec it may have them in there.

 

I will have a look now 2.0 Focus Blacktop?

 

Big ends are not listed in Haynes that I can see. Mains are 0.011 to 0.058mm

 

It’s a silver top but I think they are the same.

is that the acceptable wear limit?

Cheers

 

That was a running tolerance I think it said.

Edit running clearance.