Hi all i was wondering if someone would be willing to help me with some info iv got an escort rs turbo with a 2.1 zvh mfi and im wonting to convert it to efi, iv got the inlet manifold fuel rail and rail loom efi flywheel and crank sensor iv got a xr3i efi head i was goin to swap the internals of and put on mine so no need for conversion plates, the main thing is that iv got a full xr3i incar and engine bay loom i wont to use for this conversion and i can get hold of a ofab ecu i have read that i need to change to pins round for this to work and was wondering if any1 noes what to do and if there is anything i am missing thanks darren

 

Have a look at the stickies in the rs turbo section, there is a guide for cvh mfi-efi it should cover what you need to know.

 

If your using the Mfi bottom end your gonna have to either bore a hole for a cps bracket to pick up a signal off the efi flywheel or mount a trigger wheel on the crank pully with a bracket.You can buy these brackets new.

 

Hi iv got a zvh so it is a zetec bottom and has the crank sensor already what u need to no is what pins need changeing if i use a xr3i loom and a ofab ecu?

 

What I do no is the xr2i and 3i efi are the same loom.here is a guide on pin outs from 2i to ofab.This will sort you out.I did read a while ago that someone had plugged the ofab ecu into the 3i loom and it worked straight away with no changes.I think it depended on the yr of the car

http://www.fiestaturbo.com/forums/gu...anges-vt77331/

 

Thanks very much for ur help

 

Happy to help