Anti Roll Bar
Thread Starter
An eye for detail...
iTrader: (1)
Joined: May 2009
Posts: 1,525
Likes: 0
From: Preston, Lancs.
Anti Roll Bar
I've got a turbo technics roll bar setup for my S2 which is the same kinda setup as series 1/1600i, i think it uses the same parts.
I've only just picked it up, but i'm going to get it powder coated and refreshed so it matches the standard of my car.
What type of joints are used on the end which attaches to the bracket? I'll be replacing the bushes, and using the uprated roll-tie bar clamps. I wanted to renew the other end of the tie bar too.
Whats considered good upgrades/replacement parts for the separate tie/roll bar setup?
I've only just picked it up, but i'm going to get it powder coated and refreshed so it matches the standard of my car.
What type of joints are used on the end which attaches to the bracket? I'll be replacing the bushes, and using the uprated roll-tie bar clamps. I wanted to renew the other end of the tie bar too.
Whats considered good upgrades/replacement parts for the separate tie/roll bar setup?
Thread
Thread Starter
Forum
Replies
Last Post
nicodinho
Ford Non RS / XR / ST parts for sale.
6
Oct 7, 2015 12:56 PM