for those that still have an engine in the engine bay.

could you do me a small favour please, i need to know how big the gap is between the back of the inlet manifold and the bulkhead.

if some kind person would measure that for me id be very gratefull.

Cheers

 

Will measure it in the morning and pm you if thats ok as im out in it tomorrow

 

that will be perfect cheers mate

 

hi kelv, ive just had a look at mine for you (bt model) i make it very close to about 2 and a half inches from the back of the inlet to the bulkhead (plastic shield) maybe someone else could confirm this aswell for you.

hope this helps..

 

that sounds like a big enough gap, cheers for that.

just hope its no smaller

Ta

 

spill the beans then???