i've just had one of these put in my van, when i picked it up the sensor that makes the alam beep when you stand to close to the vechile was put on its lowest sesativaty setting.

any idea how i can make it more sensative. they said they would do it if i dropped it down the shop but the shops miles away.

thanks mike

 

Send a pm to Stu @ BSC he has a banner at the top of the page, he will be able to help.


Much Love.

 

thanks mate.

i can chage the wiper blade with the ararm set and it doesn't beep. you have to lay on the bonnet and if you lucky it will beep.

mike

 

My nephew is a clifford main dealer can ask him for the instalation book if you want it


Dave

 

that would be great mate. thanks. i've got the handbook but it doesn't say in there

thanks again

mike

 

you could have a couple of problems
1 some of the Cliffords need setting up on a pc with software (have you got it if it needed ? )

2 If it just an adjuster on the sensor control box, you gonna need to know where it been fitted. (so got to hope the company that fitted it tell you, or you gonna have to rip half the car appart )

Steve

 

Tank mike.
The hand books give you nothing, The instalation book is about 60 A4 sheets long, He wont let you have the full book , but he will let you have the pages that tells you how to adjust the sensors.


dave

 

wicked mate. thanks.
i'll paypal over some drinks.

 

Ok sort it tomorrow. let you no when done,

then let me have your address and i will post it

Dave