Jsut been on Grahams site looking at the cooler. Then been out and looked at the car where it fits and cant see any reason as to why people have probs with the bonnet catch once they have fitted it?????

 

I just shotened my catch slightly as it just rested on top of the cooler.

2 mins job...

 

The safety catch arm????

 

Yeah,the long catch bit,not the clip or anything.The bit youd lift with your fingers?

Just took about 2cm off it so it would clear ok

 

The series2 Evo4 intercooler is 22mm lower than the Evo3, which makes the installation easier if fitting the fans between the rad and intercooler, leaves clearance for the bonnet.

 

Ah right! Id buy one of ya Graham, but me being tight lol am currently got me eye on a evo3 2nd hand one. Was gonna go the 2wd cooler route but yours look that much neater i want on. If i dont get this 2nd hand for a good price ill be in touch.

How much is the evo4 mate? And whats twin pass and single pass? Excuse my thickness pmsl

 

Had no problems with the catch clearance on my EVO 3... It`s close but with careful thought when fitting it shouldn`t cause a problem.

 

 

The Evo4 is Ł265 plus postage.

The twin pass system use’s the original boost hose’s and cools the air twice.

With the single pass system you need to modify your cross over pipe to point toward the driver’s side as this where you out let pipe will be.

If you have anymore questions please let me know

 

thanks Graham! If i dont get the 2nd hand one ill be in touch(if the missus kets me pmsl)