i havn't got a piccy m8, but believe me, it was fooking touching ...

well it WAS with the mk1 servo and master cylinder... a cvh just doesnt go in properly with that setup im afraid


you need the FULL mk2 xr2 setup, ... all parts ....

servo, stubby master cylinder, servo mounting brackets both sides and the bar that goes from the pedal box to the servo..

THEN ... you have to chop a hole in the bulkhead where the bar goes through to connect to the pedal as it NOW will sit higher up, if your lucky, you will get the gromet from the mk2 and draw round it, then cut out, or its trial and error. its about the size of a 10 pkt of fags the hole you have to cut.


hope this helps m8