Originally Posted by
Marc sierra
I have removed a 94 teeth ring from a front shaft to measure it up. It's 12.4 mm wide and 70.2 mm in outer diameter. The hole in the knuckle is slightly bigger, I measured it at ~71.7 mm. Ideally I would like to fit some magnetic rings so I can run the MK60e5 system, but I can't seem to find any magnetic rings that are small enough to fit the hole in the knuckle. But I also cannot find any 48 teeth rings in a useable size.
You said you have some rings made up for the front? Where did you have those made if you don't mind me asking?
Have you already tried if the E46 rear blue sensors fit inside the hole on the Cosworth knuckle?
SORRY marc i never seen this reply
i haven't progressed any further at the minute Marc, as I am retaining my 4wd hub without shaft as I'm going 2wd on my Escos.i was looking at the possibility of machining the stubs to take a abs ring off the shelf,
the guys who can manufacture are called exmol manufacturing [gavin moss in uk].they have quoted me 150pound for a pair as they have to make a file up for machining and will take roughly 2weeks
the e46 rear sensors i think should work on both front and rear using existing holes, maybe a small bit of time to set up completely. the rear sensors read from the top like the cossie. the front BMW sensor reads from the side