I swapped out my T reg 1.25 with digital dash for a 1.7 Puma lump which had been fitted in a zetec S I got the engine bay loom , complete engine box manifold , ecu everything needed well I assume but it will not fire up the most I got was it fired but died straight away
now I’m guessing the puma loom was out off a later one as it had two lamba sensors but everything went in ok and the only management code I’m getting is fuel level sensor circuit but the gauge works fine I’m scratching my Head a bit
Originally Posted by
GM6789
Hi all,
Converting my fiesta and have nearly finished, im at the point now where the engine will turn over on the starter but it doesnt kick in to run on its own. Ive been doing all this souly off of a heynes manual (and with the determination to make the car quicker) to perform an engine change and have no outside knowlage on this so don't know where to look to solve it.
First i checked the fuel-in line and its still dry, so i checked the fuel pump on the tank and its still connected to the two pipes and electrical plug, with no leaks. is there a certain process to mannually suck through the fuel mannually to the engine because there may be air in the system as i've had to open it to change it? Like a technique to starting a dry engine?
Not sure what to do next so anything is welcome.