Hi, I am new to xr3i’s and need some advice/ anyone who can carry out the work for me...
i have recently purchased a g plate 3i cabriolet with the early type Webber iscv system, I have found out these can be troublesome!

so far the car has had new injectors, coolant temp sensor ( back of inlet manifold) plugs, leads, coil pack, iscv and TPS but the car refuses to idle when warm, starts great from cold and will tick over fine but after 10 or 15 mins the idle drops off and engine cuts out, will restart ok but won’t tick over

the car gets down the road just fine but has a little hesitation at very light constant throttle

is there a procedure for setting the idle, albeit the idle speed cannot be turned up with my type of inlet manifold?!

or even better, is anybody in the Essex or Wiltshire areas that would be willing to take a look? Paying job of course!

any help would be greatly appreciated

thanks