Just a bit of an update. Fuel tank port hole or access hatch on its way.

Please tell me how thick is the grey foam layer under the matting in the boot/trunk is? I used a 30 x 30mm ally Angle to make the frame. Want to trim it down so it don't stick out above the foam layer?

If anyone is wandering. We were careful in the measuring not to compromise the spot welded beading. We we're almost border lining

Using skid plate as a lid for the time being.

Sticking with the stock in tank fuel pump setup so access is going to be simple now.

47-01 plastic fuel tank



47-02 access hole cut / top



47-03 access hatch bottom view



47-04 access hatch ally framework and tank positioning



47-05 ally frame work taped up


47-06 ally frame welded up


47-07 Ally Frame and lid. Just needs holes drilled, clean up paint and install



Cheers