You will need the following ingredients: One prefacelift set of seats One facelift set of ST seats One facelift set of climate seats One facelift set of head rest monitor seats The material the seats are made of is immaterial �� You need the frame, foam and covers from the st seat You need the occupancy and seat position sensors from the preface seats You need the climate stuff and all the electrics and the lumbar from the climate seats You need the loom from the headrest monitor seats


You now need to turn the st base metal plate into a combination of the climate seat AND the dvd player seat, using all the brackets and drilling lots of new holes in the right places
You also need to cut two slots to mount the fans
You then need to drill 10 holes in the foam for the ventilation
Plus you need to figure out how to make the climate seat heater pad fit the st seat base as they are very different in shape, have different plugs for the loom, and have a different control box to control them
And then cut out the foam from the back rest and use the lumbar from the climate seat and some how manage to make it fit the st frame
You can keep the back heater though
Then you just need to make a hole in the leather for the headrest monitor loom plug to poke through, making sure you have an unbroken retaining clip to use to retain the loom in position or else it falls back down into the hole that's already in the seat for it to go into
I've used my full occupancy sensor on the passenger side so it all works
You also need to swap over the air bags as they are coded to the car
And the seatbelt pretensioners
And there's a fair bit of wiring in the car to sort was well, I did that when I swapped the entire dash over
It's another 4 wires you need to run plus swapping some of the loom in the plugs on the seat and the switch
I think that's about it ��