Thread
:
Peugeot 205 with 4wd cosworth engine and running gear.
View Single Post
06-04-2018, 01:20 PM
#
2008
Caddyshack
10K+ Poster!!
Join Date: Mar 2013
Location: Guildford
Posts: 10,841
Likes: 653
Received 1,031 Likes on
944 Posts
Mark has cut out all of the stuff he didn’t like ready to put in all new. The old setup had the exhaust swap sides on the car by humping over the gearbox bellhousing, this always gave ride height issues as at 3.5 inch diameter plus some air gap over the box it needed a lot of room, I have asked Mark to send the pipe straight up the car by raising the floor a bit as it then doesn’t need to cross the gearbox and it will jump over the cradle if needed as I don’t mind the boot floor being amended.
Here is a pic of the billet floor mounted pedal box, I am going to try the car without servo again as this is a better version. We have explored remote servos but prefer not to if we can get the feel right.<br/>
Reply
Like
Caddyshack
View Public Profile
Send a private message to Caddyshack
Find More Posts by Caddyshack
View iTrader Profile