Have started to make my own 6 degree rear beam last week. Was almost finished with it when I put the rear traling arms on the beam. I wan to use two bushes and not a uniball/rosejoint on the inner one, My problem is that the bushes arent aligned so i get a twisting in the bushes during suspension travel. Fail! Just have to redo the mountingpoints. My plan is to angle them the same as the outer bush.


This is how I have done it, just extended the inner pivot further to the front with a "straight" fit compared to the outer one.
This doesnt work since the bushes doesnt travel at the same angle,




But if I do like this on the picture below would that work? the inner pivot is moved forward and the bush sit at the same angle as the outer one? Or do i still get the twisting in the bushes since they are not aligned on a "line" (inner one is further to the front)





Dont want to use rosejoints on the rear end but GGMs oem style cosworth bushings. Or do u have to have rosejoint to make this work?
Hope u get my problem!

Regards Jimmy

Edit: PRAISE MY MAD PAINT SKILLZZZZZZZZZZZZZZZZZZ