Originally Posted by
scrotenz
So with the monitors that need a pectel or collins board i assume that replaces the baby board thats in the L8 as standard? Do these need any soldering or just "plug n Play"?
Where can you buy these from?
Im assuming, but will check that since i have an MSD chip that was bought back in 2011 that the comms is enabled as i read a post from 2006 that Stu said all chis from then on will have it enabled by default. This was when they started supplying the IAW software.
Also im about to install the MSD Wasted Spark kit, is there any considerations here for any of these monitoring options?
Cheers
The EPROM needs to have a data stream enabled.
The 'boards' are misunderstood, the baby board is native in the L8, if you remove it your essentially left with an L6. The Pectel board allows decryption to run Pectel's software.
Stu is probably referring to his own chips, MSD are the sole distributor of IAW, so that would figure.
No, although as you probably are aware your ECU will need drivers installed for this.
Martin