yes, only the pulley (type before think i did)...

what about copper paste to spark plugs, a small amount - put some on then wipe down into thread?
I had to use a breaker bar to get one plug out - damn the mofo who changed the plugs before... there was one or two sharp metal shavings around the hole, i carefully picked them up with a neodim magnet. The thread on the plugs is magnetic too, so i'm not sure where the shavings came form? i'll post a picture soon. it's a mean looking spike, must have been 5mm long.
[(admin, should i post this into a new thread or is it ok here?)]

should i vacuum the plug hole while turning the crank? Don't have a magnetic pickup, just a bare magnet, so i won't be poking inside i guess..