You need the Zetec 1.8 or 2.0 flywheel.

You can use either the 220mm or the 240mm flywheel. The 2.0 always has the 1" 23 spline clutch. The 220mm could have two differant sizes for the first motion shaft.

You then need either a spacer for the thrust bearing like Westfield or an extended clutch pivot like Gbs.

Starter is from the dohc.

In a 7 with a shorter sump the bottom of the bell housing is going to be around 30mm below the sump. I trimmed mine down.

The 1.8 fly is lighter than the 2.0 but the 2.0 clutch is easier and cheaper to find.