Long time no see... Few pics rest of the work that I´ve done for this car:







Painted the rollcage with some white Hammer- paint.



Random pic from the empty engine bay, note those mounts for re-positioned ARB

I also solved the becomming camber issue at the rear. Instead of adding shims between tracking arm and bearing hub, I took bit more legal way



Point was to modify those mounts in subframe. Cause there is not much space, I raised both of those "boxes" just a little, by cutting top parts off and then welding new metal to make them higher.



Both mounts raised.



Then I grinded those holes upwards half an inch, and added those stoppers that will lock up the camber adjust. I will use washers between those stoppers, and the hole for bolt, can be made high or low if using standard ride height for some reason.



Some testing with tracking arm. Fits nicely!

Also bought MT-75 gearbox:





Should sit well behind Balcktop Zetec. Needs propably release bearing from Transit as I´m using Mondeos clutch...?



Next things to do, is to make new oil sump for that engine and other preparation for RWD installation