Originally Posted by
Shaunc
Right ok I get you.
So all I need to do when refitting it fit a new pin on the clutch release bearing and I'm good?
There's no other missing part to keep it in place?.....
Also any idea at all where I might find one? Been scouring the net for ages and no joy
Right ok! So I've sorted my release bearing problem out and it just needed a new pin that holds it in at the top.
However now I have a new problem!!
I sortEd the clutch release bearing, put the gearbox back on and then when I tried to connect the clutch cable it wouldn't reach the fork because the fork bar would move it was stuck!!
So I took the gearbox back off again and had a look inside and everything looks fine. The release bearing moves forward and back freely when moving the fork bar on the bell housing so I can't see what the problem is. I have now fitted the gearbox back on the engine AGAIN!! and still the same problem, the fork will not move. What the hell is going on?!
HELP