Yes, that has been suggested. I will have another look but I don't know how much it will give me. I can space up the mounts to try it but the down pipe would need extending or the connector under v band as the pipe is very close to the front prop uj. Now the arb is out of the way we have some room to play on the pipe though.

If I can Nick a little bit on the engine then raise the ride height I might just get the driveshaft angle to a better position. The pin angle would be better and I can solve the rest of that I think.

Thanks for the input Mark. MK has suggested the same. If I go much higher then I fear the bell housing will tough the tunnel as it is pretty tight there too. I could re fab that but it would be a lot of work.