Hi peeps,

Been doing a lot of work to my 4x4 cossie lately which includes new oil pump, sump gasket, front subframe and arb powder coated and a general clean up ect ect. I sealed my sump last week and did everything needed to just start the car ie I fitted the subframe but left everything else off and sat the car on a jack. Car started fine I was happy with it no leaks ect and made good pressure.

Now this week I finished putting everything back on including steering rack, suspension, brakes ect. I was under the dash board as I was fitting a new steering column bulkhead bearing. This gives you an idea of what has changed since it started last week.

Tried starting the car but nothing, doesn't turn over and the fuel pump doesn't prime? My battery has good voltage ect, the immobiliser is disarming as it should so I know it isn't that. My fuel pump is direct from the battery and I'm sure the fuel inertia switch has been cut out in the past as its not in the boot.

Any suggestions?