A little update

So yesterday was an exspenceive day out too this lot to be powdercoated



And I payed for the all the wheel bearings and break pipes as well as new oil and filter and hydroulic cluch master cylinder. Was a bit of whack but it's all stuff that needs replacing or doing befor I can start to rebuild.

And today I got the rest of the loom disconnect and pulled up to the fuse box



And the air con box out.

The gear box was removed and cleaned up


The engine is ready to lift out and need to get the loom out and re covered before I can star putting stuff back together

I kneed to source a New fuel tank, heater fans, and ideally I would like to change the glass as my shell has all its original glass and when (if) it is sold on id like to sell it with all its glass