process of elimination replace old parts one by one till it runs, if it still as ecu remember these are sensitive also check starter motor as the can cause restart problem when hot /you could also try lifting the the sensor plate slightly while someone turns the engine over this will lift the small piston like plunger under the metering unit allowing more than usual fuel to injectors /also be carefull here though, disconnect the battery if you have tried starting the car there should still be pressure in the system ,undo each bango (separatly)to see if you have fuel getting through use some rags as you undo each one .i would say ecu..is the culprit, then fuel relay (you can bridge this by connect terminal 30-87 on the relay if i remember )check first always be safety conscious...