Evening all,

I have been on the forum a while but yet to post as usually a regular on ZSOC but as i believe i have most of the knowledge i need on the Mk4/5 to rebuild and maintain my mk4 it was about time i became more active in regards to my Mk3.

I have 2 Mk3 fiestas one which is a 1993 "K" Mk3 1.1 8v and a 1995 "M" Mk3.5 1.6 16v Zetec.

The plan is to make a 2.0 Mk3 Zetec out of the 2. I know the Zetec is the correct looms to run a Mondeo 2.0 zebec lump but after reading many threads i found there isn't a massive amount of information to go on and a lot of it is basically winging it.

For example i have read that the floor pans between the 3 and the 3.5 are different all the rest i found here http://fiestamk3parts.com/guides/use.../mk3-vs-mk3-5/

But no mention of the engine mounts my cars are geographically 30miles apart and worse still 45mins drive so I'm trying to gain as much knowledge from home as i can.

So i know i need:
2.0 Mondeo Zetec Silvertop
Desk/Dewy/Deep ECU - Very hard to find
New 1.6 water pump as they spin a different way.
130 spec inlet so its not restricted by the 1.6 inlet although would run

After that i am at a loss. I know i can run nearly all my 1.6 zetec auxiliaries to get it running as it should.

Any input would be greatly welcomed. Pics below of the 2 cars. Im going to remove all the rot and paint it so new rear arches sills and wings. Add some XR2i/RST Bumpers and skirts and she will be some where near where i want after the engine is fitted.

Andy

Mk3 1.1







Mk3.5 1.6