Had a look at the alternator today and thought it was about time to get the pulley swapped over, I had been putting this off for a while as it is a bitch to get the pulley off. I will be honest it ws probably the dodgeist removal method I have ever seen! My mate jammed a screw driver between the blades and the casing and then used a 400lb Impact/Buzz gun on it and my god did the bolt shift then! LOL!

This is an alternator that I haven't used before so we are going to test it by attaching the impact gun to the pulley and spinning it with a voltmeter attached to it, Unless anyone knows a safer method that is?

After a bit of messing around with bolt arrangements here is the before and after,

Before:



After: