Got a black 2.0 ghia hach off my mate because my bros saph needed a lockset, while I was there I noticed the underneath was pretty good so I tipped it over and cut sections out of it for the saph.







Then it was time to start the welding, took my other cossie over to work to get a shot of the pair together.



Started with the rotten front wing, cut the wing off the scrap car for this






small repair on the lip of the wing



Bit of protection while she sits outside



Started with the drivers floor, which was a mess due to being so bent, beat it flat and cut out and replaced the metal, also had to cut a couple of bits of the trans tunnel out.



Passenger floor pan, two bad bits on the transmission tunnel. the footwell had a few holes here and there.



But I decided to not fuck about and just replace all the metal and cut a big lump of the floor out.



That's now up to date, will try and get some more time on it this week, need to start ordering some panels.