Originally Posted by
Sonic Boom
While I was changing my starter motor, I noticed my inlet support bracket had broken clean in half
So I went about making something seriously stronger and better mounted too.
Wish i'd taken more photos as usual and they aren't the best quality due to poor light and being on my iPhone.
I made a little bracket out of 5mm Stainless Steel and attached that to the top bolt on the engine mounting leg, then connected the bracket to the inlet with a 130mm Turn Buckle and M8 rose joints either end.
Alot stronger now don't think i'll break this one.
Rich
Nice one, makes you wonder why Ford never made one like it.