Gonna pick up the threaded bar and some bolts and washers tomorrow, comes in at around £6.00 so very good value!!

As with most my engine stand comes with 4 fixing points, call it a stupid question but can I get away with using just 3 or must I use all 4, I want to be able to take the sump off of my Zetec and to do that I have to use the 2 threaded holes at the top of the bell housing then the 2 at the side but they look like they will all be quite close together and not sure if it will fit??

A lot of questions for what should be a simple procedure I know, but I don't want to come back to my garage with my engine lying on the floor!!