Originally Posted by Rod-Tarry

As always when i go to Marks I have more problems when i get back than before i went .
I removed the old pedal & tried the 3 options. One was a total no-go the Leon pedal could be made to fitif desperate & the Peugeot 307 pedal was simply made for the job, correct angle & length so an easy fit. As we are using only 1 pot this pedal is perfect so one problem over.
Mark then mentioned the other things he wants wired into the loom.
All 4 wheels to have wheel sensors not just 2. An input for Fuel Temp to help with mapping. Mark wants 2 map sensors one to deal with Boost below 3bar (45psi) & the other dealing with up to 4 bar (60psi). A normal 5 bar map sensor is not as stable at lower boost levels hence the ECU will be configured to switch between the 2.
I will post up the Wiring Diagram when ive made these changes its getting rather complex compared to all the other Cossie looms ive made .