Originally Posted by
Lo@der
My saff has been sat for 18mths or so and now is almost back on the road.
Ive changed front and rear brakes ( brembo's and 4wd rear calipers ), and fitted braided hoses.
Now the rears will not bleed , the pedal is hard and cant get any fluid out.
Ive done it the correct way-
ignition position 1
pasenger side rear first etc..etc..
Had a spurt of fluid for a second or two then nothing at either side rear, so i then tried the fronts and they bled up fine.
Handbrake light is staying on but no sign of the abs light at all.
The previous owner said the abs never worked and that braking was allways crap. Hence ive gone straight to brembo 330's.
I have power at one of the pins in the main plug (large bottom one) to the master cylinder/abs acumulator thingy...
HELP PLEASE !!!
Just done mine you need 2 people to bleed them front left front right left rear open bleed nipple 2nd person push peddle down to the floor hold down and turn on ignition position 2 not 1 pump should run allow fluid to flow for 15-20 seconds till no more air is visible tighten nipple and release peddle wait until pump turns off rear right as rear left but only depress peddle half way hop this helps.