[IMG][/IMG]

Head also needs a bit of work, filled the ports with fuel and within about 10 mins I lost it on 2 of the cylinders so a regrind is definitely on the cards for this weekend.

I'm hoping to have the engine together, mani ports ported out to match and new studs re tapped to hold it.

Had a bit of a brainwave regarding the breather system on the block. Could I not just make up a plate to blank off the hole and weld a tube coming out at a 90 degree angle? Would save buying a new fitting for the rear of the block and the faff of drilling and tapping. Ideas are welcomed on that 1.